Starting Operation
To start the power tool, push the on/off switch (5) forward.
To lock the on/off switch (5) in position, push the on/off switch (5) forward and down until it clicks into place.
To switch off the power tool, release the on/off switch (5); or, if the switch is locked, briefly push the on/off switch (5) backward and down and then release it.
- Always check abrasive tools before using them. The abrasive tool must be fitted properly and be able to move freely. Carry out a test run for at least one minute with no load. Do not use abrasive tools that are damaged, run untrue or vibrate during use. Damaged abrasive tools can burst apart and cause injuries.
Battery charge indicator (user interface) (31) | Meaning/cause | Solution |
|---|---|---|
Yellow | Battery almost empty | Replace or charge battery soon |
Red | Battery empty | Replace or charge battery |
Temperature indicator (36) | Meaning/cause | Solution |
|---|---|---|
Yellow | Critical temperature has been reached (motor, electronics, battery) | Run the power tool at no load and allow it to cool down |
Red | Power tool is overheated and will switch off | Leave the power tool to cool down |
Power tool status indicator (30) | Meaning/cause | Solution |
|---|---|---|
Green | Status OK | – |
Yellow | Critical temperature has been reached or rechargeable battery is almost empty | Run the power tool at no load and allow it to cool down, or replace or charge the battery soon |
Illuminated red | Power tool has overheated or rechargeable battery is empty | Allow the power tool to cool down, or replace or charge the battery |
Flashing red | KickBack control, restart protection or Drop Control has been triggered | Switch the power tool off and on again |
Indicator for cleaning the dust filter (user interface) (32) | Meaning/cause | Solution |
|---|---|---|
Yellow | Dust filter is saturated | Clean or replace the dust filter |