Documenting Measurements

The measuring tool begins to take measurements as soon as it is switched on and does so continuously until it is switched off.

To save an image, point the camera at the required measuring object and press the "Measurement" button (6). The image is saved in the measuring tool's internal memory. The measurement is frozen and shown in the display. This enables you to carefully view the image and to make retrospective adjustments (e.g. to the colour palette). If you do not wish to save the frozen image, restart measuring mode by pressing the "Measurement" button (6). If you wish to save the image in the measuring tool's internal memory, press the centre of the multi-function button (17).

Proceed as follows to call up saved thermal images:

  • Press the centre of the multi-function button (17) again immediately after saving. The preview of the most recently saved photo now appears in the display.
  • Alternatively, you can access the saved photos in the <Gallery> menu item.
  • Press the right or left of the multi-function button (17) to switch between the saved thermal images.

The visual image has been saved alongside the thermal image. Press the top or bottom of the multi-function button (17) to open this.

The measuring tool switches to full-screen view after 5 s. In the full-screen view, the title bar is hidden so that you can see all the details of the thermal image.

You can switch between views by pressing the top and bottom of the multi-function button (17).

Press the centre of the multi-function button (17) to delete individual thermal images or all thermal images at once. A submenu will open.

  • Here you can select whether you want to delete only this image or all images. Confirm the selection by pressing the centre of the multi-function button (17).
    When selecting <Delete all images>, you can choose between <Delete all>, and <Cancel>. Confirm the selection by pressing the centre of the multi-function button (17).
  • In this submenu, you can also see the information on the emissivity and reflecting temperature.

Data fragments of the images remain stored in the memory and could be reconstructed. You can select <Tool settings> → <Factory settings> in the main menu to permanently delete.