Data Transfer

Open the flap (14) for the USB Type-C® port. Connect the USB Type-C® port (15) of the measuring tool to your computer via the USB Type-C® cable (11) provided.

Now switch on the measuring tool using the on/off button (18).

Open the file browser on your computer and select the GTC_450 drive. The saved files can be copied from the internal memory of the measuring tool, moved to your computer or deleted.

As soon as you have finished the required operation, disconnect the drive from the computer following the standard procedure and then use the on/off button (18) to switch the measuring tool off again.

Caution: Always disconnect the drive from your operating system first (eject drive), as failure to do so may damage the internal memory of the measuring tool.

Remove the USB Type-C® cable and close the (14) flap.

Always keep the flap of the USB port closed so that dust and splashes cannot enter the housing.

Note: Use USB to connect the measuring tool to a computer only. The measuring tool may be damaged if connected to other devices.

Note: The USB Type-C® interface can only be used for data transfer. It is not suitable for charging non-rechargeable and rechargeable batteries.

You can post-edit the saved thermal images using special Bosch applications. Information about the applications and their compatibilities can be found on the product page of the measuring tool or at
www.bosch-professional.com or
www.bosch-professional.com/thermal.