Starting operation

Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power tool.

Products that are only sold in AUS and NZ: Use a residual current device (RCD) with a nominal residual current of 30 mA or less.

Do not stand in line with the saw blade in front of the power tool. Always stand to the side of the saw blade. This protects your body against possible kickback.

Keep hands, fingers and arms away from the rotating saw blade.
Do not reach one arm across the other when in front of the tool arm.

To start, press the on/off switch (17) and keep it pressed.

Note: For safety reasons, the on/off switch (17) cannot be locked; it must remain pressed throughout operation.

Only by pressing the locking lever (1) can the tool arm be guided downwards.

For sawing, you must therefore press the locking lever (1) in addition to pressing the On/Off switch (17).

The electronic soft start limits the torque when the power tool is switched on and increases the service life of the motor.

To switch off, release the on/off switch (17).