Fitting the Polishing Tools

Pull the plug out of the socket before carrying out any work on the power tool.

Clean the spindle (7) and all the parts to be fitted.

Lock the spindle with the spindle lock on button (3) before clamping and releasing the polishing tools.

Do not press the spindle lock on button while the spindle is moving. The power tool may become damaged if you do this.

See the graphics page for fitting instructions.

Backing pad with hook-and-loop fastening

Firmly screw the backing pad with hook-and-loop fastening (13) onto the spindle (7).

Press the polishing sponge pad with hook-and-loop fastening (15) or the polishing wool pad with hook-and-loop fastening (16) firmly against the underside of the backing pad with hook-and-loop fastening (13).

Polishing disc

Screw on the round nut (11) and tighten it with the two-pin spanner. Pull the lambswool bonnet (12) over the polishing disc (10) and tighten the fastening cords.