Maintenance and Cleaning

Before carrying out any work on the power tool (e.g. maintenance, tool change etc.), remove the battery from the power tool. There is risk of injury from unintentionally pressing the on/off switch.

To ensure safe and efficient operation, always keep the power tool and the ventilation slots clean.

A blunt diamond cup wheel (14) can be resharpened by briefly grinding abrasive material (e.g. lime-sand brick).

Store and handle the accessories carefully.

Replacing the Brush Collar

To ensure optimal dust extraction, change a worn brush collar in good time.

Press (for example with a screwdriver) into both openings (5) in the protective guard. You can remove both parts of the brush collar (4) from under the power tool. (see figure D)

Carefully push the two new parts of the brush collar (4) into the brush guide as far as they will go. When inserting the new brush collar, ensure that the ends of the brush collar are not positioned in one of the openings of the brush guide.