Starting Operation

A very large rechargeable battery will prevent the battery cover (9) from closing. In this case, the battery cover can be removed.

Push the two hinges (15) inwards against the spring force. Remove the battery cover. There is no IP protection whilst the battery cover is not in place!

To refit the battery cover (9), push the two hinges (15) inwards against the spring force again. Place the battery cover on the housing. Allow the two hinge pins to engage in the openings on the housing.

Place the worklight on a stable, level surface. Make sure it is secure.

On/off button (3)

Function

Press 1×

Switch on the light, low brightness (1st level)

Press 2×

Switch on the light, medium brightness (2nd level)

Press 3×

Switch on the light, full brightness (3rd level)

Press 4×

Switches off the worklight

If the worklight has been dimmed for approx. 5 minutes, it is switched off immediately with the next press.

If the permissible operating temperature is exceeded, the worklight switches off. Allow the worklight to cool down and switch the worklight on again.