Start-up

Pay attention to the mains voltage. The voltage of the power source must match the voltage specified on the rating plate of the power tool.

Products that are only sold in AUS and NZ: Use a residual current device (RCD) with a nominal residual current of 30 mA or less.

Fold up the safety flap (14).
To start, press the green "on" button (13).
Drop the safety flap (14) back down.

Press the off switch (15).

The power tool is equipped with an overload protection system. In normal conditions of use, the power tool cannot be overloaded. The power tool automatically switches off if it is overloaded.

Follow these steps to restart the power tool:

Switch the power tool off see Start-up.
Remove the magazine.
Then switch the power tool back on.

To protect against unauthorised use, you can lock the safety flap (14) with a padlock.

Push a padlock through the bore holes of the safety flap (14) and the off switch (15) and lock it.

Start-up

Switching on (see figure G1)

Switching off (see figure G2)

Overload protection

Protection Against Unauthorised Use (see figure G3)